Memory
64
2 Press the Set button to switch between
the memory areas of the four test param-
eters. Each time you press the Set button,
the last stored test result of each memory
area is displayed (GLUC > CHOL > TG >
LAC > GLUC >…). If the area contains no
stored results, two dashes are displayed.
To navigate within one memory area, use the
M button.
3 Press the M button to show the next
oldest result within one memory area.
When you press the button, the place of
the result within the memory is displayed
(here: 02); the actual value is not shown
until you release the button.
When you hold down the M button, older
memory places (02 … 03 … 04 … and so
on) continually appear in the display until
you release the button. Then the result in
the last displayed memory place is shown.
To Next Page
Loading...
