Roche Cedex Bio System - Page 486

Roche Diagnostics
F-16 Operator’s Manual · Version 3.1
Index Cedex Bio System
lots
– adding, B–101
– defining, B–101
– defining for calibrators, B–150
– defining for controls, B–149
– handling, B–98
– list, A–103
– viewing definitions, B–98, B–99
– viewing details of used fluids, B–100
lower-case letters, A–75
M
main calibration, E–12, E–26
maintenance
–instrument, C–5
– ISE, E–39
–overview, C–5
– screen, A–107
maintenance actions
– Abs. air/water calibration, C–28
– Activate electrodes, E–45
– Clean housing, C–21
– Clean ISE tower automatically, E–50
– Clean ISE tower manually, E–51
– Clean probe manually, C–12
– Clean reagent disk, C–14
– Clean rotor and heating channel, C–10
– Clean rotor heating channel, C–32
– Clean water and waste, C–16
– Cleanup database, C–23
– colors of entries, B–19
– Condition ISE tubing, E–46
– Contact service representative, C–27
– Daily prepare actions, E–44
– Deproteinize probe, C–10
– Electrode service, E–49
– Initialize ISE reference sensor, E–47
– Initialize ISE unit, E–53
– intervals, C–7
– intervals for ISE, E–41
– performing, C–6
– performing during End Shift phase, B–85
– performing during Prepare phase, B–19
– Prime fluid system, C–11
– Prime ISE calibrator and reference, E–48
– Replace ISE pump tubing, E–54
– Replace ISE unit tubing, E–57
– Replace photometer lamp, C–24
– Replace water inlet filter, C–19
maintenance days, B–167
manual, how to use, 5
mapping, application codes, B–160
measurements, specifications, A–65
measuring modes, ISE, E–6
messages
– alarms, A–81, D–10
– list, D–10
– overview, A–80, D–5
– screen, A–80, D–5
mixing motor, A–49
mixing reagents, B–76
– during Prepare phase, B–29
mixing rules, B–171
– definitions, B–171
– deleting, B–172
– importing, B–115
– printing, B–171
monitor
– See, alarm monitor.
monitoring
– analysis process, B–44
– ISE status, E–24
N
navigation, through screens, A–72
O
obsolete calibration, A–28
online Help, using, 5, A–79
operation
–overview, B–7
– principles, A–19
–routine, B–3
– routine ISE, E–17
–safety, A–6
operators
– qualifications, A–9
–regular breaks, A–9
optical safety, A–6
order of processing, B–44, B–145
orders
– changing, B–42
– changing with sample on board, B–42
– checking for unfinished, B–80
– defining, B–38, B–39
– defining profiles, B–148
– deleting, B–93
– handling, A–31
– IDs, A–31
– introduction to handling, A–31
– list, A–95
– order of processing, B–44
– overview, A–31
– STAT, B–41
– workflow setup, B–37