2.18
Lift the flap. The test strip must
be inserted into the measuring
chamber horizontally within
15 seconds (for the exact time
see pack insert) after applying
the sample (see “Practice with
Reflotron Check” in Section 2).
The message “PLEASE CLOSE
FLAP” confirms that the
test strip has been properly
locked into position.
If this message does not
appear when the test strip has
been inserted, proceed as
follows:
● remove the test strip
● if necessary, push the release
lever upwards
● insert the test strip again.
Display: “PLEASE CLOSE
FLAP”.
This must take place within the
given time limit (approx. 15 sec,
see above)! Otherwise a new
test strip must be used and the
process repeated.
Inserting the test strip
15 . 0 5 . 01 09 :10 : 4 0
PL E A S E CL O S E F LAP
15 . 0 5 . 01 09 :10 : 3 0
PL E A S E IN S E R T STR I P
To Next Page
Loading...