Rockwell Automation Allen-Bradley LiquiFlo 2.0 - Page 125

Rockwell Automation Publication D2-3518-4 - January 2020 125
Parameter Descriptions Chapter 9
The present value of the function selected in Testpoint 2 Sel (236).
Enables/disables annunciation of the faults shown in Figure 57
.
Figure 57 - Fault Config 1 (238)
Resets a fault and clears the fault queue. After the fault clear operation is
complete, this parameter returns to the value of 0 for Ready.
Enables/disables a fault reset (clear faults) attempt from any source.
237
Testpoint 2 Data
Range: 0...4,294,967,295 [1]
Default: 0
Access: 1 Path: Utility > Diagnostics
See also: 236
238
Fault Config 1
Range: See Figure 57
Default: See Figure 57
Access: 0 Path: Utility > Faults
See also:
240
Fault Clear
Range: 0 = Ready
1 = Clear Faults
2 = Clr Flt Que
Default: 0 = Ready
Access: 1 Path: Utility > Faults
See also:
241
Fault Clear Mode
Range: 0 = Disabled
1 = Enabled
Default: 1 = Enabled
Access: 1 Path: Utility > Faults
See also:
32
1x11000xxxxxxxxx
0011234567891112131415
1 =Enabled
0=Disabled
x =Reserved
Bit #
Factory Default Bit Values
Power Loss
UnderVoltage
Motor OverLd
Shear Pin
AutRst Tries
Decel Inhibit
Nibble 1Nibble 2Nibble 3Nibble 4