Rockwell Automation Allen-Bradley LiquiFlo 2.0 - Page 176

176 Rockwell Automation Publication D2-3518-4 - January 2020
Chapter 9 Parameter Descriptions
Writing a 1 to this parameter resets the rectifier to factory default values.
After a Reset to Defaults operation is performed, the value of this parameter
reverts back to 0 for Ready.
This parameter is not used in the Liquiflo 2.0 rectifier.
This parameter is not used in the Liquiflo 2.0 rectifier.
Writing a 1 to this parameter resets the rectifier elapsed data parameters.
After a Reset Meters operation is completed, the value of this parameter reverts
back to 0 for Ready.
This parameter is not used in the Liquiflo 2.0 rectifier.
198
Load Frm Usr Set
Range: 0...3
Default: Read Only
Access: 0 Path: Utility > Drive Memory
See also:
199
Save to User Set
Range: 0...3
Default: Read Only
Access: 0 Path: Utility > Drive Memory
See also:
200
Reset Meters
Range: 0 = Ready
1 = MWh
2 = Elapsed Time
Default: 0
Access: 0 Path: Utility > Drive Memory
See also:
201
Language
Range: 0...10
Default: Read Only
Access: 0 Path: Utility > Drive Memory
See also:
203
Drive Checksum
Range: 0...65535
Default: Read Only
Access: 0 Path: Utility > Drive Memory
See also: