Rockwell Automation PowerFlex series - Page 286

Index-18
PowerFlex Digital DC Drive User Manual - Publication 20P-UM001C-EN-P - July 2008
PID Source Gain 3-38
PID Steady Delay 3-36
PID Target 3-38
Port 1 Adapter Fault 4-5
Port 1 DPI Loss Fault 4-6
Port 2 Adapter Fault 4-5
Port 2 DPI Loss Fault 4-6
Port 3 Adapter Fault 4-5
Port 3 DPI Loss Fault 4-6
Port 4 Adapter Fault 4-5
Port 4 DPI Loss Fault 4-6
Port 5 Adapter Fault 4-5
Port 5 DPI Loss Fault 4-6
PORT LED 4-2
Port Mask Act 3-61
Potentiometer, Wiring 1-37
Power Circuit
Fuses 1-13
Protection 1-13
Power Circuit Protection
Fuse Designations - Frame A A-7
Fuse Designations - Frame B A-7
Power Failure Fault 4-6
Power Feeder Ground 1-13
Power Wiring 1-15
AC Input Contactor 1-17
Armature Converter Terminals 1-20
Armature Output Terminals 1-20
Control Circuit Terminals 1-28
DC Output Contactor 1-18
DC Output Contactor and a Dynamic
Brake 1-19
Diagrams 1-17
Field Input Terminals 1-23
Field Output Terminals 1-23
Motor Thermistor Terminals 1-25
Normally Open Contact Terminals 1-25
Powerup Delay 3-32
Preferences, Setting HIM B-5
Preset Speed 1 3-23
Preset Speed 2 3-23
Preset Speed 3 3-23
Preset Speed 4 3-23
Preset Speed 5 3-23
Preset Speed 6 3-23
Preset Speed 7 3-23
Programmable Controller Configurations
A-5
Programming 3-1
R
Ramp Delay 3-29
Ramp In 3-11
Ramp In Pct 3-11
Ramp In Zero En 3-32
Ramp Out 3-11
Ramp Out Pct 3-11
Ramp Rates Group 3-29, 3-30
Ramp Select 0 3-50
Ramp Select 1 3-50
Ramp Type Select 3-29
Rated Motor Volt 3-14
Real FF PID 3-36
Recommended AC Input Contactors A-17
Recommended AC Input Line Reactors
A-17
Recommended DC Output Contactors A-19
Recommended Dynamic Brake Resistors
A-19
Ref Line Spd 3-45
Ref Spd Source 3-45
Ref Speed Gain 3-45
Ref Zero Level 3-25
Reference Config Group 3-46
Reference Mask 3-58
Reference Owner 3-59
Regulators
Fine Tuning C-25
Relay Out 1 Sel 3-70
Relay Out 2 Sel 3-70
Relay Output Option Definitions 3-69
Relay Outputs 1-25
Removing drive covers 1-7
Frame B and C 1-8
Removing the HIM B-6
Reset Defaults 3-46
Reset Fld Curve 3-16
Reset to Defaults B-4
Restart Modes Group 3-32
Roll Diameter 3-41