Roger Technology H70/200AC - Product Description; Symbols

EN
48
2 Symbols
The symbols and their meaning in the manual or on the product label are
indicated below.
Generic danger.
Important safety information. Indicates operations and
situations in which the personnel involved must pay close
attention.
Dangerous voltage risk.
Indicates operations and situations in which the personnel
involved must pay close attention to dangerous voltages.
Hot surfaces risk.
Indicates danger due to hot surfaces or which anyway have high
temperatures (risk of burns)
Useful information
Indicates useful information for the installation.
Refer to the Installation and use instructions.
Indicates the obligation to refer to the manual or original
document, which must be available for future use and must not
be damaged in any way.
Protective earth connection point.
Indicates the admissible temperature range.
Alternating current (AC)
Direct current (DC)
Symbol for the product disposal according to the WEEE directive,
see chapter 21.
3 Product description
The H70/200AC control unit is intended to control gate automation systems with 1 or 2 asynchronous single
phase 230 V AC ROGER motors.
Use the same type of motor for both gate leaves in automation installations for double leaf swing gates.
ROGER TECHNOLOGY cannot be held responsible for any damage or injury due to improper
use or any use other than the intended usage indicated in this manual.
%HNYWXXLISTIRMRKERHGPSWYVIWTIIHHIGIPIVEXMSRERHHIPE]WIXXMRKWETTVSTVMEXIP]JSVXLIWTIGMƼGMRWXEPPEXMSR
ensuring that the gate leaves overlap correctly.
For further information, refer to the installation manual of the motor.