Roger Technology H70/200AC - Enabling Operator Present Function; Gate Open Indicator; Photocell Test Function; Set MOTOR 1 Deceleration Space (%); Set MOTOR 2 Deceleration Space (%)

EN
65
D 
Enabling operator present function.

Disabled.

Enabled. The open (AP) or close (CH) button must be pressed continuously to operate the gate. The
gate stops when the button is released.
D 
Gate open indicator / photocell test function

The indicator is off when the gate is closed, and steadily lit during manoeuvres and when the gate is open.

8LIMRHMGEXSVƽEWLIWWPS[P]HYVMRKSTIRMRKQERSIYZVIWERHMWPMXWXIEHMP][LIRXLIKEXIMWGSQ-
TPIXIP]STIR-XƽEWLIWUYMGOP]HYVMRKGPSWMRKQERSIYZVIW
If the gate is stopped in an intermediate position, the lamp extinguishes twice every 15 seconds.

Set  if the output SCMWYWIHJSVXLITLSXSGIPPXIWX7IIƼK
  
Set MOTOR 1 deceleration space (%)
N.B.: if no encoder is installed, repeat the travel acquisition procedure after any change made to this parameter.
 
Set MOTOR 2 deceleration space (%)
N.B.: if no encoder is installed, repeat the travel acquisition procedure after any change made to this parameter.

From 1% to 30% of the total gate travel.
 
LEAF 1 completely open/closed position control adjustment
N.B.: parameter visible only with encoder enabled (  or  ) and if limit switches are not
installed (  or  ).
If  , the factory value becomes .
The selected value must ensure that LEAF 1 is opened/closed correctly when it reaches the respec-
tive (open or closed) mechanical stop.
The position of LEAF 1 is calculated by the system from the number of motor revolutions and the
motor reduction gear ratio.
Warning! Excessively low values cause the gate to reverse when it reaches the gate open/closed stop.
 
LEAF 2 completely open/closed position control adjustment
N.B.: parameter visible only with encoder enabled (  or  ) and if limit switches are not
installed (  or  ).
If  , the factory value becomes .
The selected value must ensure that LEAF 2 is opened/closed correctly when it reaches the respec-
tive (open or closed) mechanical stop.
The position of LEAF 2 is calculated by the system from the number of motor revolutions and the
motor reduction gear ratio.
Warning! Excessively low values cause the gate to reverse when it reaches the gate open/closed stop.

Motor revolutions.
 
Partial opening adjustment (%)
N.B.[MXLHSYFPIPIEJW[MRKKEXIMRWXEPPEXMSRWXLMWTEVEQIXIVMWWIXF]HIJEYPXEWXLIGSQTPIXIP]
open position of LEAF 1.
With single leaf swing gate installations, this parameter is set to 50% of total opening.

From 1% to 99% of total gate travel.
 
Setting additional time after direction inversion, with no encoder
N.B.: parameter visible only if encoder is disabled  .
In the event of photocell activation or a reverse command during an opening or closing manoeuvre,
the gate reverses for the elapsed manoeuvre time plus an additional time to allow the manoeuvre
to be completed.

3 s.

6 s. Recommended setting for installations with hydraulic motors.
  
Setting automatic closing time
The timer starts from the gate open state and continues for the set time. Once the set time is
reached, the gate closes automatically. The timer count restarts if a photocell is triggered.

Pause time settable from 00 to 90 s.

Pause time settable from 2 to 9 min.