Roger Technology H70/200AC - Alarms and Faults; Mechanical Release; Position Recovery Mode

EN
75
15 Alarms and faults
PROBLEM ALARM POSSIBLE CAUSE ACTION
The gate does not open or
close.
POWER LED off No power. Check power cable.
POWER LED off Fuses blown. Replace fuse. Always disconnect from
mains power before removing fuses.
Example
 HH
 HH
'SRƼKYVEXMSRTEVEQIXIVIVVSV 7IX GSRƼKYVEXMSR ZEPYI GSVVIGXP] ERH
save.
 D&
ƽEWLMRK
Fuse F2 disconnected or damaged.
Accessories are not powered.
6IƼXJYWI*GSVVIGXP]SVVITPEGI
Acquisition procedure does
not complete correctly.
$3 3(
TEST button pressed accidentally. Repeat acquisition procedure.
Safety devices in alarm state. Press the TEST button and check the
safety device/s in alarm state and the
connections of the safety devices.
Remote control has limited
range and does not work
while automated gate is
moving.

The radio transmission is impeded by
metal structures and reinforced con-
crete walls.
Install the antenna outside.

Flat batteries. Replace the transmitter batteries.
8LIƽEWLMRKPMKLXMWRSX
working.

&YPF  0)( FPS[R SV ƽEWLMRK PMKLX
wires disconnected.
Check LED circuit and/or connector
wires.
Gate open indicator lamp
does not work.

Bulb blown or wires disconnected. Check the bulb and/or wires.
Gate does not perform
desired manoeuvre.

Motor leads crossed. Swap two wires on terminal X-Y-Z or
Z-Y-X.
N.B.4VIWWXLI8)78FYXXSRXSXIQTSVEVMP]GERGIPXLIEPEVQ8LIRI\XXMQIEGSQQERHMWVIGIMZIHXLIEPEVQ
reappears on the display if the problem has not been resolved.
16 Mechanical release
In the event of power failure, the gate may be unlocked by following the instructions given in the use and
maintenance manual of the automation system.
For further information, refer to the locking/release operation in the manual of the
automation system
3RVIGIMZMRKXLIƼVWXGSQQERHWMKREPEJXIVQEMRWTS[IVMWVIWXSVIHXLIGSRXVSPYRMXWXEVXWERSTIRMRKQERSIYZVI
in position recovery mode (see chapter 17).
17 Position recovery mode
;LIRMXVIGIMZIWXLIƼVWXGSQQERHWMKREPEJXIVETS[IVJEMPYVIEJXIVERSFWXEGPIMWHIXIGXIHMRXLIWEQITSWMXMSR
three consecutive times (with encoders enabled), the control unit starts a manoeuvre in position recovery mode .
If encoder is installed the manoeuvre in position recovery mode happens at low speed; otherwise the manoeuvre
LETTIRWEXRSVQEPWTIIH8LIƽEWLMRKPMKLXƽEWLIW[MXLEHMJJIVIRXHYX]G]GPIXLERRSVQEPWSRWSJJ
The control unit recovers the installation data during this procedure.
Warning! Do not use any controls until the gate has completed the opening and closing manoeuvre.
Position recovery is performed immediately when the limit switches (if installed) are activated.