EN
62
11 Index of parameters
PARAM.
FACTORY
DEFAULT
DESCRIPTION PAGE
$
Motor type selection 64
$
Automatic close after pause time (from gate completely open) 64
$
Automatic gate closing after mains power outage (black-out) 64
$
Selecting step mode control function (PP) 64
$
4VIƽEWLMRK 64
$
Condominium function for partial open command (PED) 64
$
Enabling operator present function. 65
$
Gate open indicator / photocell test function 65
Set MOTOR 1 deceleration space (%) 65
Set MOTOR 2 deceleration space (%) 65
Adjusting LEAF 1 position control 65
Adjusting LEAF 2 position control 65
Partial opening adjustment (%) 65
Setting additional time after direction inversion, with no encoder 65
Setting automatic closing time 65
MOTOR 1 operating time increase 66
MOTOR 2 operating time increase 66
Enable double manoeuvre time 66
Adjusting opening delay of MOTOR 2 66
Adjusting closing delay of MOTOR 1 66
Setting reverse time after activation of sensing edge or obstacle detection
(crush prevention).
66
Setting electric lock activation lead time 66
Setting electric lock activation time 66
)REFPIERXMHMWXYVFERGIƼPXIVJSVTS[IVJVSQKIRIVEXSV 66
Set motor torque during manoeuvre 66
Set motor torque during deceleration 66
Adjusting of motor torque 66
Set initial acceleration when opening/closing (soft-start) 67
Set torque after activation of sensing edge or obstacle detection system 67
Set initial maximum torque boost time 67
Set open/closed stop approach distance 67
Enable lock release reverse impulse 67
Set deceleration during opening/closure 67
Set obstacle detection sensitivity during manoeuvres 67
Set obstacle detection sensitivity during deceleration 67
Number of automatic closure attempts after activation of sensing edge or
obstacle detection (crush protection)
68
Setting photocell mode during gate opening (FT1) 68
Setting photocell mode during gate closing (FT1) 68
To Next Page
Loading...
