Roger Technology H70/200AC - MOTOR 1 Operating Time Increase; MOTOR 2 Operating Time Increase; Enable Double Manoeuvre Time; Adjusting Opening Delay of MOTOR 2

EN
66
 
MOTOR 1 operating time increase
N.B.: parameter visible only if encoder is disabled  .
Additional time (in seconds) added to the operation time programmed during the acquisition phase.
It is NOT necessary to repeat the travel acquisition.
 
MOTOR 2 operating time increase
N.B.: parameter visible only if encoder is disabled  .
Additional time (in seconds) added to the operation time programmed during the acquisition phase.
It is NOT necessary to repeat the travel acquisition.

from 0 to 10 s of manoeuvre.
 
Enable double manoeuvre time
Enabling this parameter is recommended for installations with particularly long operating times.
N.B.: parameter visible only if encoder is disabled  .

Disabled.

Enabled.
 
Adjusting opening delay of MOTOR 2
During opening, MOTOR 2 starts with an adjustable delay after MOTOR 1.

From 0 to 10 s.
 
Adjusting closing delay of MOTOR 1
During closing, MOTOR 1 starts with an adjustable delay after MOTOR 2.

From 0 to 60 s.
 
Setting reverse time after activation of sensing edge or obstacle detection
(crush prevention).
This sets the reverse manoeuvre time after activation of the sensing edge or the obstacle detection
system.

From 0 to 60 s.
 
Set electric lock activation lead time
Sets the electric lock activation time before any manoeuvre.

From 0 to 2 s.
 
Enable electric lock
Sets duration of electric lock activation time.

Disabled.

Enabled, with time from 1 to 6 s.
This parameter must be set to a value higher than parameter  (if enabled).
 
)REFPIERXMHMWXYVFERGIƼPXIVJSVTS[IVJVSQKIRIVEXSV

Disabled.

)REFPIH8LMWTEVEQIXIVIREFPIWEWYTTPIQIRXEV]HMKMXEPƼPXIVJYRGXMSRXSMQTVSZIXLISTIVEXMSRSJXLI
control unit when powered by a generator and optimise motor control.
  
Set motor torque during open/close manoeuvre
This parameter must always be equal to or less than the value set for parameter .

4 = minimum motor torque ... 8 = maximum motor torque.
 
Set motor torque during deceleration

4 = minimum motor torque ... 8 = maximum motor torque.
 
Set motor torque boost at start of manoeuvre

1 = minimum motor torque ... 8 = maximum motor torque.