Roger Technology H70/200AC - Parameter Menu; Motor Type Selection; Automatic Close after Pause Time (from Gate Completely Open); Automatic Gate Closing after Mains Power Outage (Black-Out)

EN
64
12 Parameter menu
PARAMETER PARAMETER
VALUE
$  
Motor type selection

Standard motor (4-pole) - (and all existing codes with the exception of the following codes for the
value $)

Slow motor (6-pole) - (R20/302, R20/502, R21/368, H23/282, R41/832, R41/833)
$ 
Automatic closure after pause time (from gate completely open)

Disabled.

From 1 to 15 of gate closure attempts after photocell is triggered.
Once the number of attempts set is reached, the gate remains open.

8LIKEXIXVMIWXSGPSWIMRHIƼRMXIP]
$ 
Automatic gate closing after mains power outage

Disabled. The gate does not close automatically when mains power is restored.

Enabled. If the gate is NOT completely open, when mains power is restored, the gate closes after a
WIGSRH[EVRMRKWMKREPPIH[MXLXLIƽEWLMRKPMKLXMRHITIRHIRXP]SJXLIZEPYIWIX[MXLXLITEVEQIXIV
$). The gate closes in “position recovery” mode (see chapter 17).
$ 
Selecting step mode control function (PP)

Open-stop-close-stop-open-stop-close...

'SRHSQMRMYQJYRGXMSRXLIKEXISTIRWERHGPSWIWEJXIVXLIWIXEYXSQEXMGGPSWMRKXMQI
The automatic closing timer restarts if a new step mode command is received.
Step mode commands are ignored while the gate is opening. This allows the gate to open com-
pletely and prevents the gate from closing when not required.
If automatic closing is disabled ($ ), the condominium function automatically attempts a closing
manoeuvre $ .

'SRHSQMRMYQJYRGXMSRXLIKEXISTIRWERHGPSWIWEJXIVXLIWIXEYXSQEXMGGPSWMRKXMQI
The automatic closing timer does NOT restart if a new step mode command is received.
Step mode commands are ignored while the gate is opening. This allows the gate to open com-
pletely and prevents the gate from closing when not required.
If automatic closing is disabled ($ ), the condominium function automatically attempts a closing
manoeuvre $ .

Open-close-open-close.

Open-close-stop-open.
D 
4VIƽEWLMRK

(MWEFPIH8LIƽEWLMRKPMKLXMWEGXMZEXIHHYVMRKSTIRMRKERHGPSWMRKQERSIYZVIW

Flashing warning signal for 1 to 10 seconds prior to every manoeuvre.

WIGSRHƽEWLMRK[EVRMRKWMKREPTVMSVXSGPSWMRKQERSIYZVI
D 
Condominium function for partial open command (PED)

(MWEFPIH8LIKEXISTIRWTEVXMEPP]MRWXITQSHISTIRWXSTGPSWIWXSTSTIR

Enabled. Partial commands are ignored during gate opening.