Roger Technology H70/200AC - Selecting Courtesy Light Mode

EN
70
 
'SRƼKYVMRKWIRWMRKIHKI COS1

Sensing edge NOT INSTALLED.

NC contact (normally closed). The gate reverses only when opening.

Contact with 8k2 resistor. The gate reverses only when opening.

NC contact (normally closed). The gate always reverses.

Contact with 8k2 resistor. The gate always reverses.
 
'SRƼKYVMRKWIRWMRKIHKI COS2

Sensing edge NOT INSTALLED.

NC contact (normally closed). The gate reverses only when closing.

Contact with 8k2 resistor. The gate reverses only when closing.

NC contact (normally closed). The gate always reverses.

Contact with 8k2 resistor. The gate always reverses.
 
'SRƼKYVIIRGSHIV
N.B.: if no encoder is installed, time based control is used.
MJXLMWTEVEQIXIVMWQSHMƼIHHMWGSRRIGXJVSQ:%'QEMRWTS[IV[EMXJSVXLIHMWTPE]XSXYVR
off then reconnect to mains power. 6ITIEXEGUYMWMXMSRTVSGIHYVIWII'LETXIV

No encoder installed.

Optical encoders installed (8 pulses/revolution).

E30 Series. Magnetic encoders installed (1 pulse/revolution)

R21 series (version V.1). Magnetic encoders installed (1 pulse/revolution).
 
'SRƼKYVMRKVEHMSGLERRIP46
 
'SRƼKYVMRKVEHMSGLERRIP46

STEP MODE.

PARTIAL OPENING

OPENING

CLOSING.

STOP.

Courtesy light. The output COR is managed from the remote control. The light remains lit as long as
the remote control is active. The parameter  is ignored.

Courtesy light ON-OFF (PP). The output COR is managed from the remote control.
The remote control turns the courtesy light on and off. The parameter  is ignored.

FLASHING LIGHT. The FLASHING LIGHT output is managed from the remote control. The light re-
mains lit as long as the remote control is active. The parameter  is ignored.

FLASHING LIGHT ON-OFF. The FLASHING LIGHT output is managed from the remote control.
The remote control turns the courtesy light on and off. The parameter  is ignored.
 
'SRƼKYVMRKƽEWLMRKPMKLXJVIUYIRG]

8LIJVIUYIRG]MWWIXIPIGXVSRMGEPP]JVSQXLIƽEWLMRKPMKLXYRMX

7PS[ƽEWL

0MKLXƽEWLIWWPS[P][LIRKEXISTIRWVETMHP][LIRKEXIGPSWIW
 
Selecting courtesy light mode

Disabled.

4907)8LIGSYVXIW]PMKLXMPPYQMREXIWFVMIƽ]EXXLIWXEVXSJIEGLQERSIYZVI

ACTIVE. The light remains lit for the entire duration of the manoeuvre.

From 3 to 90 s. The light remains lit for the time period set after the manoeuvre is completed.

From 2 to 9 minutes. The light remains lit for the time period set after the manoeuvre is completed.