Roger Technology H70/200AC - Initial Testing; Start-Up; Maintenance; Disposal

EN
76
18 Initial testing
8LIXIWXMRKQYWXFITIVJSVQIHF]UYEPMƼIHXIGLRMGEPTIVWSRRIP
The installer is required to measure impact forces and select on the control unit the
appropriate speed and torque values to ensure that the motorised door or gate remains
[MXLMRXLIPMQMXWHIƼRIHF]XLIWXERHEVHW)2ERH)2
Make sure that the provisions in Chapter 1 "GENERIC WARNINGS are observed.
• Turn on the power supply.
• Check that all connected controls are working correctly.
• Check travel and deceleration.
• Check that the impact force is correct, in compliance with EN 12453 and EN12445.
• Check that the safety devices are activated correctly
• Disconnect from mains power then reconnect.
• Starting with the gate stopped in an intermediate position, check that the position
recovery procedure is completed correctly for both the open and closed positions.
• Check the limit switch settings (if installed).
• Check that the release system works correctly.
19 Start-up
8LIMRWXEPPIVMWVIUYMVIHXSHVE[YTERHTVIWIVZIXLIXIGLRMGEPƼPISJXLIW]WXIQJSVEXPIEWX]IEVW[LMGLQYWX
contain the wiring diagram, the drawing and the photo of the system, the risk analysis and the solutions adopted,
the manufacturer's declaration of conformity for all connected devices, the instructions manual of each device and
/ or accessory and the system's maintenance plan.
Apply a plate indicating the automation system data on the motorised door or gate, the name of the person in
charge of the start-up, the serial number and the year of construction, as well as the CE mark.
Apply a plate and / or label with the indications for the operations required to manually unlock the system.
Draw up and provide the end user with the declaration of conformity, instructions and warnings for use and the
maintenance plan.
Make sure that the end user has understood the correct automatic, manual or emergency operation of the system.
Inform the end user about the dangers and risks that may be presen
20 Maintenance
Perform scheduled maintenance every 6 months.
Check cleanliness and function.
If the unit contains dirt, moisture, insects or other foreign matter, disconnect from mains power and clean the
board and the housing.
Repeat the initial installation test procedure after cleaning.
If any corrosion is found on the printed circuit board, evaluate if it is necessary to replace the board itself.
21 Disposal
The TVSHYGXQE]SRP]FIYRMRWXEPPIHF]UYEPMƼIHXIGLRMGEPTIVWSRRIPJSPPS[MRK
suitable procedures for removing the product correctly and safely. This product
consists of numerous different materials. Some of these materials may be
VIG]GPIH[LMPISXLIVWQYWXFIHMWTSWIHSJGSVVIGXP]EXXLIWTIGMƼGVIG]GPMRKSV
waste management facilities indicated by local legislation applicable for this
category of product.
Do not dispose of this product as domestic refuse. Observe local legislation for differentiated
refuse collection, or hand the product over to the vendor when purchasing an equivalent
new product.
0SGEPPIKMWPEXMSRQE]IRZMWEKIWIZIVIƼRIWJSVXLIMRGSVVIGXHMWTSWEPSJXLMWTVSHYGX
Warning! Some parts of this product may contain substances that are harmful to the
environment or dangerous and which may cause damage to the environment or health risks
if disposed of incorrectly.