Roger Technology H70/200AC - Commands and Accessories

EN
52
6 Commands and Accessories
If not installed, safety devices with NC contacts must be jumpered at the COM terminals, or disabled by
modifying the parameters , ,, ,and .
/)=
N.A. (Normally Open).
N.C. (Normally Closed).
CONTACT DESCRIPTION
10(COR) 11
Output (potential free contact) for connecting courtesy light. :EG;ƼK
12(LAM)
13
'SRRIGXMSRJSVƽEWLMRKPMKLX (potential free contact):EG;ƼK
8LIWIXXMRKWJSVXLITVIQERSIYZVIƽEWLMRK[EVRMRKWMKREPQE]FIWIPIGXIH[MXL
parameter $[LMPIXLIƽEWLMRKQSHIMWWIX[MXLTEVEQIXIV.
14 15(ANT)
Antenna connector for slot-in radio receiver board.
9WI6+MJERI\XIVREPERXIRREMWYWIHQE\MQYQVIGSQQIRHIHPIRKXLQ
N.B.HSRSXQEOINSMRXWMRGEFPI
16 17 19
+5V
ENC1
COM
13836)2'3()6GSRRIGXMSRƼK
Encoders are disabled by default ( ).
WARNING! Always disconnect from electrical power before disconnecting or
connecting the encoder cable.
16 18 19
+5V
ENC2
COM
13836)2'3()6GSRRIGXMSRƼK
Encoders are disabled by default ( ).
WARNING! Always disconnect from electrical power before disconnecting or
connecting the encoder cable.
20(FCA1) 24(COM)
-RTYX2'JSVGSRRIGXMRKSTIRPMQMXW[MXGLJSV13836ƼK
The activation of the limit switch during door stop opening 1 (motor 1).
21(FCC1) 24(COM)
-RTYX2'JSVGSRRIGXMRKGPSWIHPMQMXW[MXGLJSV13836ƼK
The activation of the limit switch during closing of sash stop 1 (motor 1).
22(FCA2) 24(COM)
-RTYX2'JSVGSRRIGXMRKSTIRPMQMXW[MXGLJSV13836ƼK
The activation of the limit switch during sash stop opening 2 (motor 2).
23(FCC2) 24(COM)
-RTYX2'JSVGSRRIGXMRKGPSWIHPMQMXW[MXGLJSV13836ƼK
Activation of the limit switch during closing of sash stop 2 (motor 2).
26(ORO) 25(COM)
Clock timer contact input (N.O.).
When the clock function is active, the gate opens and remains open.
At the end of the programmed time set with the external device (clock), the gate
closes.
The function of this command is determined by parameter .
27(AP) 31(COM)
Open control signal input (N.O.).
28(CH) 31(COM)
Close command input (N.O.).
29(PP) 31(COM)
Step by step mode command input (N.O.).
The function of the control is determined by parameter $.