EasyManua.ls Logo

Roger Technology H70/200AC - Restoring Factory Default Values; HW Version; Year of Manufacture; Week of Manufacture

Roger Technology H70/200AC
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EN
71
 
'PSGOGSRXEGXGSRƼKYVEXMSR
When the clock function is active, the gate opens and remains open.
At the end of the programmed time set with the external device (clock), the gate closes.

When the clock function is active, the gate opens and remains open. Any command signal received
is ignored.

When the clock function is active, the gate opens and remains open. Any command signal received
is accepted. When the gate returns to the completely open position, the clock function is reactivated.
 
Restoring factory default values
NOTE This procedure is only possible is NO data protection password is set.
P1
P2
x4 s
+
-
Warning!6IWXSVMRKHIJEYPXWIXXMRKWGERGIPWEPPWIXXMRKWQEHITVIZMSYWP]EJXIVVIWXSVIGLIGOXLEXEPP
parameters are suitable for the installation.
The default factory settings may also be restored using the + (PLUS) and/or - (MINUS) buttons as
JSPPS[W
Turn off the power.
Press and hold the + (PLUS) and - (MINUS) buttons until the unit switches on.
• The message U(V flashes on the display after 4 s.
The default factory settings have now been restored.
-HIRXMƼGEXMSRRYQFIV
8LIMHIRXMƼGEXMSRRYQFIVGSRWMWXWSJXLIZEPYIWSJXLITEVEQIXIVWJVSQQ to Q.
N.B.8LIZEPYIWWLS[RMRXLIXEFPIEVIMRHMGEXMZISRP]
Q 
HW version.
)\EQTPI
Q 
Year of manufacture.
Q 
Week of manufacture.
Q 
Serial number.
Q 
Q 
Q 
FW version.
View manoeuvre counter
The number consists of the values of the parameters from R to R multiplied by 100.
N.B.8LIZEPYIWWLS[RMRXLIXEFPIEVIMRHMGEXMZISRP]
R 
Manoeuvres performed.
Examplex100 = 12.300 manoeuvres.
R 
View manoeuvre hour counter
The number consists of the values of the parameters from K to K.
N.B.8LIZEPYIWWLS[RMRXLIXEFPIEVIMRHMGEXMZISRP]
K 
Manoeuvre hours.
)\EQTPI = 123 hours.
K 
View control unit days on counter
The number consists of the values of the parameters from G to G.
N.B.8LIZEPYIWWLS[RMRXLIXEFPIEVIMRHMGEXMZISRP]
G 
Days with unit switched on.
)\EQTPI = 123 days.
G 

Table of Contents

Other manuals for Roger Technology H70/200AC

Related product manuals