Rohde & Schwarz FSWP Series - Configuring Level Characteristics

Remote Commands for the I/Q Analyzer
R&S
®
FSWP
111User Manual 1177.5856.02 ─ 07
Parameters:
<Value> bit values in hexadecimal format
TTL type voltage levels (max. 5V)
Range: #B00000000 to #B00111111
Example:
OUTP:UPOR #B00100100
Sets pins 5 and 7 to 5 V.
OUTPut<up>:UPORt:STATe <State>
This command toggles the control lines of the user ports for the AUX PORT connector.
This 9-pole SUB-D male connector is located on the rear panel of the R&S FSWP.
Suffix:
<up>
.
irrelevant
Parameters:
<State> ON | OFF | 0 | 1
OFF | 0
User port is switched to INPut
ON | 1
User port is switched to OUTPut
Example:
OUTP:UPOR:STAT ON
8.6.3 Configuring Level Characteristics
Commands useful to configure level characteristics described elsewhere:
●
[SENSe:]ADJust:LEVel on page 139
CALCulate<n>:MARKer<m>:FUNCtion:REFerence............................................................111
CALCulate<n>:UNIT:POWer............................................................................................112
DISPlay[:WINDow<n>]:TRACe<t>:Y[:SCALe]:RLEVel........................................................112
DISPlay[:WINDow<n>]:TRACe<t>:Y[:SCALe]:RLEVel:OFFSet............................................112
[SENSe:]POWer:NCORrection........................................................................................ 113
CALCulate<n>:MARKer<m>:FUNCtion:REFerence
This command matches the reference level to the power level of a marker.
If you use the command in combination with a delta marker, that delta marker is turned
into a normal marker.
Suffix:
<n>
.
Window
<m> Marker
Example:
CALC:MARK2:FUNC:REF
Sets the reference level to the level of marker 2.
Configuring I/Q Analyzer Measurements