Rohde & Schwarz FSWP Series - 8.6.13 Configuring the Result Display

Remote Commands for the I/Q Analyzer
R&S
®
FSWP
139User Manual 1177.5856.02 ─ 07
See "Adjusting settings automatically during triggered measurements" on page 66.
Parameters:
<State> ON | OFF | 0 | 1
OFF | 0
Switches the function off
ON | 1
Switches the function on
[SENSe:]ADJust:FREQuency
This command sets the center frequency to the frequency with the highest signal level
in the current frequency range.
Example:
ADJ:FREQ
Manual operation: See " Adjusting the Center Frequency Automatically ( Auto Fre-
quency )" on page 67
[SENSe:]ADJust:LEVel
This command initiates a single (internal) measurement that evaluates and sets the
ideal reference level for the current input data and measurement settings. This ensures
that the settings of the RF attenuation and the reference level are optimally adjusted to
the signal level without overloading the R&S FSWP or limiting the dynamic range by an
S/N ratio that is too small.
Example:
ADJ:LEV
Manual operation: See " Setting the Reference Level Automatically ( Auto Level )"
on page 49
8.6.13 Configuring the Result Display
DISPlay:FORMat........................................................................................................... 140
DISPlay[:WINDow<n>]:SIZE........................................................................................... 140
LAYout:ADD[:WINDow]?................................................................................................. 140
LAYout:CATalog[:WINDow]?............................................................................................141
LAYout:IDENtify[:WINDow]?............................................................................................ 142
LAYout:REMove[:WINDow]............................................................................................. 142
LAYout:REPLace[:WINDow]............................................................................................ 142
LAYout:SPLitter..............................................................................................................143
LAYout:WINDow<n>:ADD?............................................................................................. 144
LAYout:WINDow<n>:IDENtify?........................................................................................ 145
LAYout:WINDow<n>:REMove..........................................................................................145
LAYout:WINDow<n>:REPLace........................................................................................ 145
Configuring I/Q Analyzer Measurements