Rohde & Schwarz FSWP Series - Configuring Trigger Output

Remote Commands for the I/Q Analyzer
R&S
®
FSWP
124User Manual 1177.5856.02 ─ 07
*RST: IMMediate
Example:
TRIG:SOUR EXT
Selects the external trigger input as source of the trigger signal
Manual operation: See " Trigger Source " on page 55
See " Free Run " on page 55
See "Ext. Trigger 1/2" on page 55
See " IF Power " on page 55
See " I/Q Power " on page 56
See " RF Power " on page 56
See " Time " on page 56
TRIGger[:SEQuence]:TIME:RINTerval <Interval>
This command defines the repetition interval for the time trigger.
Parameters:
<Interval> 2.0 ms to 5000
Range: 2 ms to 5000 s
*RST: 1.0 s
Default unit: S
Example:
TRIG:SOUR TIME
Selects the time trigger input for triggering.
TRIG:TIME:RINT 50
The measurement starts every 50 s.
Manual operation: See " Repetition Interval " on page 57
8.6.9 Configuring Trigger Output
OUTPut<up>:TRIGger<tp>:DIRection.............................................................................. 124
OUTPut<up>:TRIGger<tp>:LEVel.................................................................................... 125
OUTPut<up>:TRIGger<tp>:OTYPe..................................................................................125
OUTPut:TRIGger<tp>:PULSe:IMMediate..........................................................................126
OUTPut:TRIGger<tp>:PULSe:LENGth............................................................................. 126
OUTPut<up>:TRIGger<tp>:DIRection <Direction>
This command selects the trigger direction for trigger ports that serve as an input as
well as an output.
Suffix:
<up>
.
irrelevant
<tp> Selects the used trigger port.
<2>: selects trigger port 2 (on the rear panel).
Parameters:
<Direction> INPut | OUTPut
INPut
Port works as an input.
Configuring I/Q Analyzer Measurements