Rohde & Schwarz FSWP Series - 5 Configuration; Configuration Overview

Configuration
R&S
®
FSWP
36User Manual 1177.5856.02 ─ 07
5 Configuration
The I/Q Analyzer is a special application on the R&S FSWP, which you activate using
the [MODE] key on the front panel.
When you switch to an I/Q Analyzer measurement channel the first time, a set of
parameters is passed on from the currently active application. After initial setup, the
parameters for the measurement channel are stored upon exiting and restored upon
re-entering the channel. Thus, you can switch between applications quickly and easily.
When you activate a measurement channel for the I/Q Analyzer application, data
acquisition from the input signal is started automatically with the default configuration.
It can be configured in the I/Q Analyzer "Overview" dialog box, which is displayed
when you select the "Overview" softkey from any menu.
The main configuration settings and dialog boxes are also available via the "I/Q Ana-
lyzer" menu which is displayed when you press the [MEAS CONFIG] key.
The remote commands required to perform these tasks are described in Chapter 8.6,
"Configuring I/Q Analyzer Measurements", on page 105.
Importing and Exporting I/Q Data
The I/Q data to be evaluated in the I/Q Analyzer application can not only be captured
by the I/Q Analyzer itself, it can also be imported to the R&S FSWP, provided it has the
correct format. Furthermore, the captured I/Q data from the I/Q Analyzer can be expor-
ted for further analysis in external applications.
For details see Chapter 4.4, "I/Q Data Import and Export", on page 27.
● Configuration Overview...........................................................................................36
● Import/Export Functions..........................................................................................38
● Configuring Data Inputs and Outputs......................................................................41
● Configuring the Amplitude.......................................................................................47
● Configuring Frequency Characteristics...................................................................52
● Configuring Triggered Measurements.....................................................................54
● Data Acquisition and Bandwidth Settings............................................................... 58
● Display Configuration..............................................................................................65
● Adjusting Settings Automatically.............................................................................66
5.1 Configuration Overview
Throughout the measurement channel configuration, an overview of the most important
currently defined settings is provided in the "Overview". The "Overview" is displayed
when you select the "Overview" icon, which is available at the bottom of all softkey
menus.
Configuration Overview