Rohde & Schwarz FSWP Series - Initiate:sequencer:abort; Initiate:sequencer:immediate; Initiate:sequencer:mode; Initiate<N>[:Immediate]

Remote Commands for the I/Q Analyzer
R&S
®
FSWP
90User Manual 1177.5856.02 ─ 07
OFF | 0
Single measurement
*RST: 1
Example:
INIT:CONT OFF
Switches the measurement mode to single measurement.
INIT:CONT ON
Switches the measurement mode to continuous measurement.
Manual operation: See " Continuous Sweep / Run Cont " on page 64
INITiate<n>[:IMMediate]
This command starts a (single) new measurement.
With measurement count or average count > 0, this means a restart of the correspond-
ing number of measurements. With trace mode MAXHold, MINHold and AVERage, the
previous results are reset on restarting the measurement.
You can synchronize to the end of the measurement with *OPC, *OPC? or *WAI.
Suffix:
<n>
.
irrelevant
Example:
INIT:CONT OFF
Switches to single measurement mode.
DISP:WIND:TRAC:MODE AVER
Switches on trace averaging.
SWE:COUN 20
Sets the measurement counter to 20 measurements.
INIT;*WAI
Starts the measurement and waits for the end of the 20 mea-
surements.
Manual operation: See " Single Sweep / Run Single " on page 65
INITiate:SEQuencer:ABORt
This command stops the currently active sequence of measurements. The Sequencer
itself is not deactivated, so you can start a new sequence immediately using
INITiate:SEQuencer:IMMediate on page 90.
To deactivate the Sequencer use SYSTem:SEQuencer on page 94.
Usage:
Setting only
INITiate:SEQuencer:IMMediate
This command starts a new sequence of measurements by the Sequencer.
Its effect is similar to the INITiate<n>[:IMMediate] command used for a single
measurement.
Performing Measurements