Analysis
R&S
®
FSWP
69User Manual 1177.5856.02 ─ 07
6 Analysis
General result analysis settings concerning the trace, markers, lines etc. can be config-
ured via the "Analysis" button in the "Overview". They are similar to the analysis func-
tions in the Spectrum application, except for the features described here.
For more information, please refer to the R&S FSWP User Manual.
● Trace Configuration.................................................................................................69
● Marker Settings.......................................................................................................70
● Display Lines and Limit Lines..................................................................................70
6.1 Trace Configuration
Access
●
"Overview" > "Analysis" > "Trace"
For more information, refer to the R&S FSWP user manual.
Spectrograms in the I/Q analyzer
Basically, spectrograms work the same as in the spectrum application (including the
3D spectrogram).
However, in the I/Q analyzer, they have the following distinctive features.
●
Not all result displays support spectrograms.
●
Compared to the spectrum application, a spectrogram can not be added as an
independent result display. Instead, spectrograms relate to a certain measurement
window (or result display). Result diagram and spectrogram are a single entity in
that case and can not be divided.
●
You can assign a specific trace to the spectrogram.
To view results in a spectrogram, select a window (indicated by a blue frame), then
select [TRACE] > "Spectrogram Config".
Spectrograms are either displayed in "Split" mode (spectrogram is displayed below the
trace diagram), in "Full" mode (trace diagram is not displayed), or not displayed at all
("Off)".
When the "Spectrogram Config" softkey is greyed out, spectrograms are not supported
by the selected result display.
State..............................................................................................................................69
Trace............................................................................................................................. 70
State
Activates and deactivates a Spectrogram subwindow.
"Split"
Displays the Spectrogram as a subwindow in the original result dis-
play.
Trace Configuration
To Next Page
Loading...
