Configuration
R&S
®
FSWP
58User Manual 1177.5856.02 ─ 07
For gated measurements in "Edge" mode, the slope also defines whether the gate
starts on a falling or rising edge.
Remote command:
TRIGger[:SEQuence]:SLOPe on page 123
5.7 Data Acquisition and Bandwidth Settings
Access: "Overview" > "Bandwidth"
● Data Acquisition...................................................................................................... 58
● Sweep Settings....................................................................................................... 63
5.7.1 Data Acquisition
Access: "Overview" > "Bandwidth" > "Data Acquisition" tab
The data acquisition settings define which parts of the input signal are captured for fur-
ther evaluation in the applications.
Figure 5-1: Data acquisition settings with advanced FFT parameters
MSRA operating mode
In MSRA operating mode, only the MSRA Master channel actually captures data from
the input signal. The data acquisition settings for the I/Q Analyzer application in MSRA
mode define the analysis interval.
For details on the MSRA operating mode see the R&S FSWP MSRA User Manual.
The remote commands required to configure the data acquisition are described in
Chapter 8.6.11, "Configuring Data Acquisition", on page 128.
Sample Rate ................................................................................................................ 59
Analysis Bandwidth ......................................................................................................59
Maximum Bandwidth ....................................................................................................59
200 MHz Filter...............................................................................................................60
Meas Time ....................................................................................................................60
Data Acquisition and Bandwidth Settings
To Next Page
Loading...
