Rohde & Schwarz FSWP Series - Page 37

Configuration
R&S
®
FSWP
37User Manual 1177.5856.02 ─ 07
In addition to the main measurement settings, the "Overview" provides quick access to
the main settings dialog boxes. The individual configuration steps are displayed in the
order of the data flow. Thus, you can easily configure an entire measurement channel
from input over processing to output and analysis by stepping through the dialog boxes
as indicated in the "Overview".
The Overview varies depending on the application; for detailed descriptions see the
corresponding application User Manual.
The "Overview" for the I/Q Analyzer Master provides quick access to the following con-
figuration dialog boxes (listed in the recommended order of processing):
1. Configuring the input
See Chapter 5.3.1, "Inputs", on page 41
2. Configuring level characteristics
See Chapter 5.4, "Configuring the Amplitude", on page 47
3. Configuring Frequency Characteristics
See Chapter 5.5, "Configuring Frequency Characteristics", on page 52
4. Configuring triggered and gated measurements
See Chapter 5.6, "Configuring Triggered Measurements", on page 54
5. Configuring the output
See Chapter 5.3.2, "Outputs", on page 45
6. Configuring the bandwidth
See Chapter 5.7, "Data Acquisition and Bandwidth Settings", on page 58
7. Analyzing results
See the User Manual of the R&S FSWP
8. Configuring the display
See Chapter 5.8, "Display Configuration", on page 65
To configure settings
► Select any button in the "Overview" to open the corresponding dialog box.
Configuration Overview