Rohde & Schwarz FSWP Series - Page 125

Remote Commands for the I/Q Analyzer
R&S
®
FSWP
125User Manual 1177.5856.02 ─ 07
OUTPut
Port works as an output.
*RST: INPut
Manual operation: See "Trigger 1/2" on page 46
OUTPut<up>:TRIGger<tp>:LEVel <Level>
This command defines the level of the (TTL compatible) signal generated at the trigger
output.
This command works only if you have selected a user defined output with
OUTPut<up>:TRIGger<tp>:OTYPe.
Suffix:
<up>
.
1..n
<tp> Selects the trigger port to which the output is sent.
2 = trigger port 2 (rear)
Parameters:
<Level> HIGH
5 V
LOW
0 V
*RST: LOW
Example:
OUTP:TRIG2:LEV HIGH
Manual operation: See " Level " on page 47
OUTPut<up>:TRIGger<tp>:OTYPe <OutputType>
This command selects the type of signal generated at the trigger output.
Suffix:
<up>
.
1..n
<tp> Selects the trigger port to which the output is sent.
2 = trigger port 2 (rear panel)
Parameters:
<OutputType> DEVice
Sends a trigger signal when the R&S FSWP has triggered inter-
nally.
TARMed
Sends a trigger signal when the trigger is armed and ready for
an external trigger event.
UDEFined
Sends a user defined trigger signal. For more information see
OUTPut<up>:TRIGger<tp>:LEVel.
*RST: DEVice
Configuring I/Q Analyzer Measurements