Welcome to the I/Q Analyzer Application
R&S
®
FSWP
12User Manual 1177.5856.02 ─ 07
MSRA operating mode
In MSRA operating mode, additional tabs and elements are available. A colored back-
ground of the screen behind the channel tabs indicates that you are in MSRA operating
mode.
For details on the MSRA operating mode see the R&S FSWP MSRA User Manual.
Channel bar information
In the I/Q Analyzer application, the R&S FSWP shows the following settings:
Table 2-1: Information displayed in the channel bar for the I/Q Analyzer application
Ref Level Reference level
Att RF attenuation
Ref Offset Reference level offset
Freq Center frequency
Meas Time Measurement time
Rec Length Defined record length (number of samples to capture)
SRate Defined sample rate for data acquisition
RBW (Spectrum evaluation only) Resolution bandwidth calculated from the
sample rate and record length
In addition, the channel bar also displays information on instrument settings that affect
the measurement results even though this is not immediately apparent from the display
of the measured values (e.g. transducer or trigger settings). This information is dis-
played only when applicable for the current measurement. For details see the
R&S FSWP Getting Started manual.
Window title bar information
For each diagram, the header provides the following information:
Figure 2-2: Window title bar information in the I/Q Analyzer application
1 = Window number
2 = Window type
3 = Trace color
4 = Trace number
5 = Detector
6 = Trace mode
Diagram footer information
The information in the diagram footer (beneath the diagram) depends on the evalua-
tion:
Understanding the Display Information
To Next Page
Loading...
