Rohde & Schwarz FSWP Series - Page 74

How to Work with I/Q Data
R&S
®
FSWP
74User Manual 1177.5856.02 ─ 07
2. Press the [MODE] key and select the I/Q Analyzer or any other application that
supports I/Q data.
3. Configure the data acquisition.
4. Press the [RUN SINGLE] key to perform a single sweep measurement.
5.
Select the
"Save" icon in the toolbar.
6. Select the "I/Q Export" softkey.
7. In the file selection dialog box, select a storage location and enter a file name.
8. Select "Save" .
The captured data is stored to a file with the extension .iq.tar.
Importing I/Q data
1. Press the [MODE] key and select the "I/Q Analyzer" or any other application that
supports I/Q data.
2. If necessary, switch to single sweep mode by pressing the [RUN SINGLE] key.
3.
Select the
"Open" icon in the toolbar.
4. Select the "I/Q Import" softkey.
5. Select the storage location and the file name with the .iq.tar file extension.
6. Select "Open" .
The stored data is loaded from the file and displayed in the current application.
Previewing the I/Q data in a web browser
The iq-tar file format allows you to preview the I/Q data in a web browser.
1. Use an archive tool (e.g. WinZip® or PowerArchiver®) to unpack the iq-tar file
into a folder.
2. Locate the folder using Windows Explorer.
3. Open your web browser.
How to Export and Import I/Q Data