Rohde & Schwarz FSWP Series - Page 85

Remote Commands for the I/Q Analyzer
R&S
®
FSWP
85User Manual 1177.5856.02 ─ 07
Application <ChannelType> Parameter Default Channel Name*)
Noise Figure Measure-
ments (R&S FSWP-K30)
NOISE Noise
Spurious Measurements
(R&S FSWP-K50)
SPUR Spurious
Transient Analysis
(R&S FSWP-K60)
TA Transient Analysis
Vector Signal Analysis
(R&S FSWP-K70)
DDEM VSA
Note: the default channel name is also listed in the table. If the specified name for a new channel already
exists, the default name, extended by a sequential number, is used for the new channel.
INSTrument:REName <ChannelName1>, <ChannelName2>
This command renames a channel.
Setting parameters:
<ChannelName1> String containing the name of the channel you want to rename.
<ChannelName2> String containing the new channel name.
Note that you cannot assign an existing channel name to a new
channel; this will cause an error.
Channel names can have a maximum of 31 characters, and
must be compatible with the Windows conventions for file
names. In particular, they must not contain special characters
such as ":", "*", "?".
Example:
INST:REN 'PhaseNoise','PNO'
Renames the channel with the name 'PhaseNoise' to 'PNO'.
Usage: Setting only
INSTrument[:SELect] <ChannelType> | <ChannelName>
This command activates a new channel with the defined channel type, or selects an
existing channel with the specified name.
Also see
●
INSTrument:CREate[:NEW] on page 83
Parameters:
<ChannelType> Channel type of the new channel.
For a list of available channel types see INSTrument:LIST?
on page 84.
<ChannelName> String containing the name of the channel.
Activating I/Q Analyzer Measurements