Rohde & Schwarz FSWP Series - Page 99

Remote Commands for the I/Q Analyzer
R&S
®
FSWP
99User Manual 1177.5856.02 ─ 07
64
64-bit floating-point numbers
Compared to REAL,32 format, twice as many numbers are
returned.
Example:
FORM REAL,32
FORMat:DEXPort:DSEParator <Separator>
This command selects the decimal separator for data exported in ASCII format.
Parameters:
<Separator> POINt | COMMa
COMMa
Uses a comma as decimal separator, e.g. 4,05.
POINt
Uses a point as decimal separator, e.g. 4.05.
*RST: *RST has no effect on the decimal separator.
Default is POINt.
Example:
FORM:DEXP:DSEP POIN
Sets the decimal point as separator.
Manual operation: See " Decimal Separator " on page 40
FORMat:DEXPort:FORMat <FileFormat>
Determines the format of the ASCII file to be imported or exported. Depending on the
external program in which the data file was created or will be evaluated, a comma-sep-
arated list (CSV) or a plain data format (DAT) file may be required.
Parameters:
<FileFormat> CSV | DAT
*RST: DAT
Example:
FORM:DEXP:FORM CSV
Manual operation: See " File Type " on page 40
MMEMory:STORe<n>:TRACe <Trace>, <FileName>
This command exports trace data from the specified window to an ASCII file.
Secure User Mode
In secure user mode, settings that are stored on the instrument are stored to volatile
memory, which is restricted to 256 MB. Thus, a "memory limit reached" error can occur
although the hard disk indicates that storage space is still available.
To store data permanently, select an external storage location such as a USB memory
device.
For details, see "Protecting Data Using the Secure User Mode" in the "Data Manage-
ment" section of the R&S FSWP base unit user manual.
Retrieving Results