Rohde & Schwarz NRPxxA Series - Page 52

Browser-Based User Interface
R&S
®
NRPxxA(N)
52User Manual 1177.6017.02 ─ 05
Trigger Source...............................................................................................................52
└ <Source>........................................................................................................ 52
└ <Slope>...........................................................................................................52
Trigger Level................................................................................................................. 52
Trigger Delay.................................................................................................................52
Dropout......................................................................................................................... 53
Holdoff...........................................................................................................................53
Hysteresis..................................................................................................................... 53
Trigger Source
Groups the trigger source settings.
<Source> ← Trigger Source
Selects the trigger source. See Chapter 9.5.2.3, "Trigger Sources", on page 73.
Remote command:
TRIGger:SOURce on page 82
<Slope> ← Trigger Source
Sets the polarity of the active slope of the trigger signal that is externally or internally
applied.
"Positive"
The rising edge of the trigger signal is used for triggering.
"Negative"
The falling edge of the trigger signal is used for triggering.
Remote command:
TRIGger:SLOPe on page 82
Trigger Level
Sets the trigger threshold for internal triggering derived from the test signal.
Remote command:
TRIGger:LEVel on page 81
TRIGger:LEVel:UNIT on page 81
Trigger Delay
Sets the delay between the trigger event and the beginning of the actual measurement.
Settings