R&S SU 4200 Troubleshooting
6125.0226.12.01 4.12
Code Message Level Config Note Action
0343 SNMP WD RESTART W –- Indication of a restart
caused by a problem
with the internal SNMP
agent.
This may be a software
error. Please report it to
the service. Restart and
observe.
If this fails to eliminate
the fault, send the radio
to service.
0344 BOOT ERROR W –- There was at least one
error during the last
booting. The list of
errors can be read out
via the remote control.
Read out the error via
remote control and
check the
troubleshooting for this
command. If the error
occurs again after
troubleshooting and the
reboot, send the radio to
service.
Last Page of Chapter 4\\Last Page of Chapter 4 "Radio".doc
To Next Page
Loading...
