R&S ZVL GUI Reference
Trace Menu
Operating Manual 1303.6580.32-06
179
Markers must be inside the sweep range and have a valid response value when they are fixed.
• D
el
ta Mode sets the selected marker to delta mode and displays its values relative to the
reference marker.
• Discrete Mode means that a marker can be set to discrete sweep points only. If discrete mode is
switched off, the marker can be positioned on any point of the trace, and its response values are
obtained by interpolation.
• All Mkrs Coupled couples the markers of all traces in the active setup to the markers of the active
trace; see Coupled Markers.
The Style settings qualify how the selected marker is displayed on the screen.
The Show Info settings select the marker info to be displayed at the Marker Position, in the marker info
field or in a separate Table below the diagram area. The display options may be selected simultaneously
or all switched off. The table provides more information than the marker info field:
The Reduced table provides a condensed overview with less entries.
Remote control:
CALCulate<Chn>:MARKer<Mk>[:STATe] ON
CA
LC
ulate<Chn>:MARKer<Mk>:TYPE NORMal | FIXed
CALCulate<Chn>:MARKer<Mk>:REFerence:TYPE NORMal | FIXed
CALCulate<Chn>:MARKer<Mk>:DELTa[:STATe] ON
CALCulate<Chn>:MARKer<Mk>:MODE CONTinuous | DISCrete
CALCulate<Chn>:MARKer<Mk>:COUPled[:STATe] ON
Export Mkrs...
Calls up a Save As... dialog to store the current marker values to a marker file.
The analyzer uses a simple ASCII format to export marker values. By default, the marker file extension is
*.txt. The file contains all traces in the active setup together with their names and measured quantities.
Below each trace, the file shows a list of all markers with their names, stimulus and response values.
The following example of a marker file describes a setup with two traces Trc1 and its memory trace. Trc1
has no markers assigned, the memory trace has four markers named Mkr 1, ..., Mkr 4.
Remote control:
MMEMory:STORe:MARKer "file_name"
Meas
The Measure submenu selects the quantity to be measured and displayed.
To Next Page
Loading...
