R&S ZVL Command Reference
Instrument-Control Commands
Operating Manual 1303.6580.32-05
444
Example:
See TRACe[:DATA][:RESPonse][:ALL]?
The following parameters are related to trace data (see also Data Flow diagram):
FDATa
Formatted trace data, according to the selected trace format (CALCulate<Chn>:FORMat
). 1 value per trace point for
Cartesian diagrams, 2 values for polar diagrams.
SDATa
Unformatted trace data: Real and imaginary part of each measurement point. 2 values per trace point irrespective of the
se
lected trace format. The trace mathematics is not taken into account.
MDATa
Unformatted trace data (see SDATa
) after evaluation of the trace mathematics.
HCOPy...
The HCOPy system controls the output of screen information to an external device. The instrument allows
two independent printer configurations which can be set separately with the numeric suffix <1|2>. Part of
the functionality of this system is included in the File menu.
HCOPy[:IMMediate<config>] <numeric_value>
Starts a hardcopy output.
<config>
1 | 2 - Printer configuration to be used for the hardcopy output. If there is no
suffix, configuration 1 is automatically selected.
<numeric_value>
1 | 2 - Starts the hardcopy output to device 1 (default) or 2.
*RST value -
SCPI, Command
Types
Confirmed, no query
Example:
See HCOPy[:IMMediate<config>]:NEXT
HCOPy[:IMMediate<config>]:NEXT <numeric_value>
Starts a hardcopy output. If the output is printed to a file (see HCOPy:DESTination<1|2>), the file name
used in the last saving process is automatically counted up to the next unused name.
<config>
1 | 2 - Printer configuration to be used for the hardcopy output. If there is no
suffix, configuration 1 is automatically selected.
<numeric_value>
1 | 2 - Starts the hardcopy output to device 1 (default) or 2.
*RST value -
SCPI, Command
Types
Confirmed, no query
Example:
HCOP:DEV:LANG BMP
Select the data format
HCOP:DEST 'MMEM'
Direct the hardcopy to a file.
To Next Page
Loading...
