Rohde & Schwarz ZVL series - Channel Manager; Delete Channel

R&S ZVL GUI Reference
Channel Menu
Operating Manual 1303.6580.32-06
266
CALCulate<Ch>:PARameter:SDEFine "<Trc_name>", "<Parameter>"
DISPlay:WINDow<No>:STATe ON
DISPlay:WINDow<No>:TRACe:FEED "<Trc_name>"
Delete Channel
Deletes the current channel including all traces assigned to the channel and removes all display elements
related to the channel from the diagram area. Delete Channel is disabled if the setup contains only one
channel: In manual control, each setup must contain at least one diagram area with one channel and one
trace.
To restore a channel that was unintentionally deleted, use the Undo function.
Remote control:
CONFigure:CHANnel<Ch>[:STATe] OFF
Channel Manager
Opens a dialog to perform the actions in the Channel Select menu systematically and rename channels.
All existing channels of the current setup are listed in a table; see below. Below the table the Trace
Manager provides the following buttons:
• Add Channel adds a new channel to the list. The new channel is named Ch<n>, where <n> is the
largest of all existing channel numbers plus one.
• Delete Channel deletes the channel selected in the drop-down menu. This button is disabled if the
setup contains only one channel: In manual control, each setup must contain at least one diagram
area with one channel and one trace.
Columns in the Channel Manager table
The channel table contains several editable (white) or non-editable (gray) columns.
• Channel indicates the current channel name. The default names for new channels are Ch<n>
where <n> is a current number.