R&S ZVL GUI Reference
SETUP Key
Operating Manual 1303.6580.32-06
291
Install Option
Opens an edit dialog box to enter the license key for the option that you want to install. A message box
opens if an option is about to expire or has already expired (in which case all functions (including remote
control) are unavailable until the R&S ZSL is rebooted). For more information about the option in question
refer to the System Info softkey in the setup menu.
Shutdown Off/Standby
Defines the effect of the power on/off key on the front panel, if the R&S ZVL is AC-supplied (see
Instrument States with AC Power Supply):
• Off: The instrument is completely turned off. To prevent the instrument from overheating, the fan
remains active.
• Standby: The instrument is switched to standby mode.
Preset Network
Sets the preset mode to network analyzer. The instrument is set to this mode when a preset is performed
(PRESET key or *RST command).
Preset Spectrum
Sets the preset mode to spectrum analyzer. The instrument is set to this mode when a preset is performed
(PRESET key or *RST command).
General Setup
Opens a submenu for all general settings such as IP address and LAN settings, date and time, remote
control (optional) and MEAS display.
Menu (Key) Submenu Submenu / Command Submenu / Command
SETUP g General Setup g Configure Network
Network Address g
LXI g
GPIB g
Time+Date
Meas Display g
More g Monitor Int / Ext
Soft Frontpanel
To Next Page
Loading...
