Rohde & Schwarz ZVL series - Description; Info; LAN Status On;Off; Password

R&S ZVL GUI Reference
SETUP Key
Operating Manual 1303.6580.32-06
294
Menu (Key) Submenu Submenu /
Comm
and
Submenu /
Command
SETUP g General
Setup g
LXI g LAN Status On/Off
Info
Password
Description
LAN Reset
For a description of the LXI browser interface of the R&S ZVL refer to LXI Configuration.
LAN Status On/Off
Activates the LAN status bar that shows the current status of the LAN connection. Depending on the
status of the connection, the LXI logo assumes the following states:
• Red: no connection is established
• Green: connection established
• Blinking: the device could not be identified
Info
Shows the current LXI parameters of the analyzer. The R&S ZVL displays the current LXI version, LXI
class and various system parameters like computer name or IP adress.
While active, the dialog is not updated.
Remote control:
SYSTem:LXI:INFO?
Password
Shows the current LXI password. You can also change the current password using this softkey. Some
settings in the LXI web browser (e.g. IP parameters) are password-protected. An empty password is not
valid, i.e. you must enter a password.
By default, the password is LxiWebIfc.
Remote control:
SYSTem:LXI:PASSword
Description
Opens a dialog box to view or change the LXI instrument description. This description appears on the LXI
browser interface. By default, the description contains the serial number of the network analyzer.