R&S ZVL Preparing for Use
Rear Panel Tour
Quick Start Guide 1303.6538.62 - 06
19
1.2 Rear Panel Tour
This section gives an overview of the rear panel controls and connectors of the
network analyzer.
The following rear panel connectors require special attention:
C The (fuse-protected) mains connector in the lower left corner is used to connect
the analyzer to the AC power supply; see Power on and off.
C The DC power supply connector and the Battery Pack are alternatives for the AC
power supply via the mains connector; see DC Power Supply and Battery.
C LAN is used to connect the analyzer to a Local Area Network; see Remote
Operation in a LAN.
The remaining rear connectors are described in detail in the annex Hardware
Interfaces in the online help system.
C EXT. TRIGGER / GATE IN is an input for external TTL trigger signals.
C EXT REF serves as an input for an external 10 MHz reference signal.
The following connectors require additional hardware options (see rear panel labeling):
C POWER SENSOR is used for connecting power sensors of the R&S NRP-Zxy
family.
C Noise Source Control provides the supply voltage for an external noise source.
C IF/VIDEO OUT is an output for the IF signal or video signal.
C AUX PORT provides control signals for external devices.
C OCXO provides the internal 10 MHz reference signal, which may be used to
synchronize external devices. The connector can be used as an input for external
reference signals, too.
C IEC Bus is the GPIB bus connector (according to standard IEEE 488 / IEC 625).
To Next Page
Loading...
