Rohde & Schwarz ZVL series - Disconnect Network Drive; Map Network Drive; SETUP Key

R&S ZVL GUI Reference
SETUP Key
Operating Manual 1303.6580.32-06
288
Remote Control:
MM
EM
:NETW:USED
MMEM:NETW:UNUS?
Map Network Drive
Changes the focus to the Drive list.
Remote Control:
MMEM:NETW:MAP
Disconnect Network Drive
Opens a dialog to disconnect a (previously connected) network drive.
Remote Control:
MMEM:NETW:DISC
SETUP Key
The SETUP key is used to set or display the default settings of the instrument: reference frequency, date,
time, LAN interface, firmware update and enabling of options, information about instrument configuration
and service support functions.
The following table shows all softkeys available in the setup menu. It is possible that your instrument
configuration does not provide all softkeys. If a softkey is only available with a special option, model or
(measurement) mode, this information is delivered in the corresponding softkey description.
Submenu / Command Submenu / Command Submenu / Command
Reference Int/Ext
General Setup g Configure Network
Network Address g Computer Name
IP Address
Subnet Mask
DHCP On/Off
LXI g LAN Status On/Off
Info
Password
Description