R&S ZVL Command Reference
Instrument-Control Commands
Operating Manual 1303.6580.32-05
386
Create the reference marker and display it in the center of the sweep range.
CALC:MARK:REF:Y?
Query the measurement value at the reference marker position.
CALCulate<Chn>:MARKer<Mk>SEARch:BFILter:RESult[:STATe] <Boolean>
Shows or hides the bandfilter search results in the diagram area.
<Chn>
Channel number used to identify the active trace.
<Mk>
Marker number in the range 1 to 10. This numeric suffix is ignored and may be set to
any value.
<Boolean>
ON - Show the bandfilter search results. If no bandfilter search has been initiated
before (CALCulate<Chn>:MARKer<Mk>:FUNCtion:EXECute BFILter),
nothing is displayed.
OFF - hide the bandfilter search results.
*RST value OFF
SCPI,
Command
Types
Device-specific, command or query.
Example:
See CALCulate<Chn>:MARKer<Mk>:BWIDth.
CALCulate<Chn>:MARKer<Mk>:SEARch[:IMMediate]
Initiates a search according to the search function selected with
CALCulate<Chn>:MARKer<Mk>:FUNCtion[:SELect]. The marker must be created before using
CALCulate<Chn>:MARKer<Mk>[:STATe] ON.
Note: Together with CALCulate<Chn>:MARKer<Mk>:FUNCtion[:SELect] this command is the ZVR-
compatible equivalent of CALCulate<Chn>:MARKer<Mk>:FUNCtion:EXECute ....
<Chn>
Channel number used to identify the active trace.
<Mk>
Marker number in the range 1 to 10. For a bandfilter search (BFILter) this
numeric suffix is ignored and may be set to any value because the bandfilter
search functions always use markers Mkr1 to Mkr4.
Range [def.
unit]
– [–]
*RST value –
SCPI,
Command
Types
Device-specific, no query.
CALCulate<Chn>:MARKer<Mk>:SEARch:LEFT
Selects a search mode for marker no. <Mk> and initiates a search for the next valid peak to the left. The
marker must be created before using CALCulate<Chn>:MARKer<Mk>[:STATe] ON.
To Next Page
Loading...
