Rohde & Schwarz ZVL series - Page 414

R&S ZVL Command Reference
Instrument-Control Commands
Operating Manual 1303.6580.32-05
399
Delete the ripple limit range, select complex units for the ripple limit.
CALCulate<Chn>:RIPPle:SEGMent<Seg>:COUNt?
Queries the number of ripple limit ranges.
<Chn>
Channel number used to identify the active trace.
<Seg>
Ripple limit range number. This suffix is ignored; the command counts all ranges.
Response
0 | 1 | ...- number of (enabled or disabled)) ripple limit ranges.
*RST value 0
SCPI,
Command
Types
Device-specific, query only.
Example:
*RST; CALC:RIPP:DATA 1,1500000000, 2000000000,3, 1, 2000000000, 3000000000, 5
Define and enable a ripple limit range in the stimulus range between 1.5 GHz and 2
GHz, assigning a ripple limit of +3 dBm. Define and enable a second ripple limit
range in the stimulus range between 2 GHz and 3 GHz, assigning a ripple limit of +5
dBm.
CALC:RIPP:SEGM:COUNT?
Query the number of ranges. The response is 2.
CALCulate<Chn>:RIPPle:SEGMent<Seg>:LIMit <limit_value>
Defines the ripple limit for ripple limit range no. <Seg>. A range must be created first to enable this
command (e.g CALCulate<Chn>:RIPPle:DATA).
To define several ripple limit ranges with a single command, use CALCulate<Chn>:RIPPle:DATA.
<Chn>
Channel number used to identify the active trace.
<Seg>
Segment number
<limit_value>
Limit value, to be defined in accordance with the selected format
(CALCulate<Chn>:RIPPle:RDOMain:FORMat).
Range [def. unit]
Almost no restriction for limit ranges; see Rules for Limit Line Definition.
[Hz]
*RST value – (no ripple limit line defined after *RST)
SCPI, Command
Types
Device-specific, with query.
Example:
See CALCulate<Chn>:RIPPle:SEGMent<Seg>:STIMulus:STARt.
CALCulate<Chn>:RIPPle:SEGMent<Seg>:RESult?
Returns the result of the ripple limit check in the previously defined limit range no. <Seg>.