R&S ZVL Command Reference
Instrument-Control Commands
Operating Manual 1303.6580.32-05
401
of 5 dB.
CALC:RIPP:SEGM:STAT OF
Disable the limit check in the modified stimulus range.
CALCulate<Chn>:RIPPle:SEGMent<Seg>:STIMulus:STOP <stop_value>
Changes the stop stimulus value (i.e. the largest stimulus value) of a ripple limit range. A range must be
created first to enable this command (e.g CALCulate<Chn>:RIPPle:DATA).
To define several ripple limit ranges with a single command, use CALCulate<Chn>:RIPPle:DATA.
<Chn>
Channel number used to identify the active trace.
<Seg>
Segment number
<stop_value>
Frequency value.
Range [def. unit]
Almost no restriction for limit ranges; see Rules for Limit Line Definition.
[Hz. For distance-to-fault traces the default unit is the length unit defined via
UNIT:LENGth.]
*RST value – (no ripple limit line defined after *RST)
SCPI, Command
Types
Device-specific, with query.
Example:
See CALCulate<Chn>:RIPPle:SEGMent<Seg>:STIMulus:STARt.
CALCulate<Chn>:RIPPle:SEGMent<Seg>[:STATe] <Boolean>
Enables or disables the limit check in the ripple limit range no. <Seg>.
<Chn>
Channel number used to identify the active trace.
<Seg>
Segment number
<Boolean>
ON | OFF - Limit check on or off. A result is available even if the limit check is
disabled; see example for CALCulate<Chn>:RIPPle:SEGMent<Seg>:RESult?.
*RST value – (no ripple limit line defined after *RST)
SCPI,
Command
Types
Device-specific, command or query.
Example:
See CALCulate<Chn>:RIPPle:SEGMent<Seg>:STIMulus:STARt.
CALCulate<Chn>:RIPPle:STATe <Boolean>
Switches the global ripple limit check on or off. This check covers all traces in the active setup.
Use CALCulate<Chn>:RIPPle:SEGMent<Seg>[:STATe] to switch the limit check for a single
ripple limit range on or off.
<Chn>
Channel number used to identify the active trace.
To Next Page
Loading...
