Rohde & Schwarz ZVL series - Page 438

R&S ZVL Command Reference
Instrument-Control Commands
Operating Manual 1303.6580.32-05
423
<Ph_pt>
Physical port number
<no>
Number of resistance in circuit model. If unspecified the numeric suffix is set to
1.
Range [def. unit] 1 to 3 [–] The number of resistances depends on the selected circuit model.
Parameters
Possible circuit models (character data); see circuit models.
*RST value – (see command type description below)
<numeric_value>
Resistance R<no> for the specified circuit model.
Range [def. unit] –10 MV to 10 MV [V]. The increment is 1 mV (10
–3
V).
*RST value 0 V for all resistances connected in series with an inductance
10 MV for all resistances connected in parallel with a capacitance
SCPI, Command
Types
Device-specific, command or query. In the query form, the <numeric_value>
parameter must be omitted. The command returns the resistance value for the
specified circuit model.
Example:
*RST; CALC:TRAN:VNET:SEND:EMB:PAR:R1? CSL; R2? CSL
Query the default resistances for the Serial C, shunt L circuit model. The
response is 10000000; 0.
CALC:TRAN:VNET:SEND:EMB:PAR:R2 CSL, 2.2E+3
Increase the resistance R2 to 2.2 kV.
CALCulate<Ch>:TRANsform:VNETworks:SENDed:EMBedding<Ph_pt>[:STATe]
<Boolean>
Enables or disables the embedding function. It is allowed to change the circuit model and its parameters
while embedding is enabled.
<Ch>
Channel number.
<Ph_pt>
Physical port number
<Boolean>
ON – Embedding active
OFF – Embedding inactive
*RST value OFF [–]
SCPI, Command
Types
Device-specific, command or query
Example:
CALC:TRAN:VNET:SEND:EMB:TND CSL
Select the Serial C, shunt L circuit model for embedding.
CALC:TRAN:VNET:SEND:EMB:PAR:R2 CSL, 2.2E+3; CALC:TRAN:VNET:SEND:EMB ON
Increase the resistance R2 for the Serial C, shunt L circuit model to 2.2 kV
and enable embedding.
CALCulate<Ch>:TRANsform:VNETworks:SENDed:EMBedding<Ph_pt>:TNDefinitio
n FIMPort | CSL | LSC | CSC | LSL | SLC | SCL | SCC | SLL
Selects the circuit model for sembedding.