Roland Soljet EJ-640 - Drying the Trailing Edge of the Printing Area on the Dryer

Fully Utilizing the Media Heating System
4
Advanced Functions
88

Press or to select a setting.
Press
to conrm your entry.
MENU
The system performs heating to the set temperature at all times, without lowering
the temperature during preheating.
30°C
The system maintains a temperature of 30°C (86°F) during preheating.
OFF
The system switches the media heating system o during preheating.

Press , then to go back to the original screen.
Default Setting
[PREHEATING]: 30°C (86°F)
Drying the Trailing Edge of the Printing Area on the Dryer
Procedure

Hold down and press .

Press to display the screen shown on the left.
Press
.

Press or to select "ENABLE."
Press
to conrm your entry.

Press , then to go back to the original screen.
Description
 "Enable": Media feeding is performed until the trailing edge of the printing area is positioned on the dryer. The
margin between the print-end position and the next print-start position is set to a value of 125 mm (4.9 in.).
If you set the margin to a value that is greater than or equal to the above value in the software RIP, the
software's setting is used.
 P. 89, "Using an Optional Dryer"
 "DISABLE": Media feeding stops when printing ends. This means that the trailing edge of the printing area
is not fed to the dryer unless you continue with a subsequent printing operation.
Default Setting
[FEED FOR DRY]: DISABLE
PREHEATING
30゜C MENU
HEATER MENU
FEED FOR DRY
FEED FOR DRY
DISABLE ENABLE