Roland SP-404MK2 - Appendix; Parameter Guide; System

Appendix
108
Appendix
Parameter Guide
SYSTEM
GENERAL
Parameter
Value
Explanation
Edit Knob
Mode
This sets how the values change when you move the knobs.
CATCH
When you move a knob, control data is only outputted when the position of the
knob reaches or “catches up” to the value of its internal parameter.
● In “Mixing the Samples (DJ MODE)(P.77)”, the knobs work in CATCH mode,
regardless of the settings.
DIRECT
When you move a knob, the control data (current position) is always outputted.
EFX Knob
Mode
This sets how the values change when you move the knobs.
CATCH
When you move a knob, control data is only outputted when the position of the
knob reaches or “catches up” to the value of its internal parameter.
DIRECT
When you move a knob, the control data (current position) is always outputted.
Manual
When you switch effects, control data corresponding to the position of the knob is
outputted.
Load Project
This sets the project that loads when the unit starts up.
Last
Loads the project that was used right before the power was last turned off.
1–16
Loads a specified project.
Sub Pad Mode
This sets the functionality of the [SUB PAD] button in sample mode.
Retrig
Retriggers the current pad (plays its sound again).
SkipBack
Switches to skip-back mode.
Auto Trig
Level
1–10
Sets the level at which note input is detected (the level at which sampling
automatically starts, and the level at which recording to the skip-back memory
begins).
Scrn Saver
Time
1, 5, 10 (min)
Sets the time before the screen saver starts (in minutes).
Scrn Saver
Type
OldRave, Naminori
Selects the type of screen saver.
Custom
When you select “Custom”, you can use an image file that you’ve imported as the
screen image for the screen saver (Customizing the Screen Saver(P.89)).
Disp Off
Select “Disp Off” to turn off the display.
BPM Auto
Dtct
ON, OFF
When this is set to “ON”, the tempo (BPM) is automatically detected when you
import a sample.
BPM Detect
Range
100-199, 80-159,
70-139, 50-99
Selects the range at which the tempo (BPM) of a sample is automatically detected.
Pad Mute
When Pad Mute is on, this selects whether to monitor the muted samples.
Mst+Phn
Muted samples are not outputted to any jack.
Master
Muted samples can be output (monitored) from the PHONES jack. In this case, no
effects are applied.
PTN Change
Mode
This sets how the samples play back when switching between patterns during pattern playback.
MKII
Sample playback stops when the pattern changes.
SX
Sample playback continues when the pattern changes.
Pop-up Time
Normal, Short, OFF
Sets how long the popup screens are displayed.
Set this to “Short” to make the popup screens display for a shorter time than the
“Normal” setting.
Set this to “OFF” if you don’t want popups to display.
SBS Time
Sets the recording time for skip-back memory.
Def
Recording time: 25 sec (max.)
Long
Recording time: 40 sec (max.)