Roland SP-404MK2 - Slicer; Tremolo;Pan; Chromatic PS; Hyper-Reso

Appendix
121
Parameter
Value
Explanation
BPF
Applies the effect over a narrow frequency range.
SYNC
OFF, ON
When this is ON, the effect sound synchronizes with the
tempo.
Slicer
This slices the sound up into small pieces, creating the impression that a backing phrase is being played.
This slices up the sound at certain intervals into 16 parts (16 steps), breaking the sound into a rhythm that follows the sequence
pattern (a pattern used for slicing up the sound). This is effective when used with sustaining sounds.
Parameter
Value
Explanation
PATTERN
1–32
Sets the sequence pattern.
SPEED
0–100 (when the SYNC parameter is
OFF)
2/1 to 1/64T (bars; when the SYNC
parameter is ON)
Sets the period over which the sequence pattern repeats.
DEPTH
0–100
Sets the slicing depth. Larger settings make the slicing effect more
prominent.
SHUFFLE
0–100
Larger settings delay the timing of even-numbered steps (2, 4...).
MODE
Sets how the volume changes when the next step sounds.
LEGATO
The volume is not changed between steps.
SLASH
The volume is reset to zero before the next step sounds (at the
boundary between steps).
SYNC
OFF, ON
When this is ON, the effect sound synchronizes with the tempo.
Tremolo/Pan
Cyclically varies the volume or panning.
Parameter
Value
Explanation
DEPTH
0–100
Sets the depth of the effect.
RATE
0–100 (when the SYNC parameter is OFF)
1.000–0.010 (when the SYNC parameter is
ON)
Sets the cycle (period) of the effect.
TYPE
Sets the type of effect.
TRE
Cyclically changes the volume (tremolo).
PAN
Cyclically changes the panning.
WAVE
Sets how the effect modulates the sound.
TRI
Triangle wave
SQR
Square wave
SIN
Sine wave
SAW1, SAW2
Sawtooth wave
TRP
Trapezoidal wave
SYNC
OFF, ON
When this is ON, the effect sound synchronizes with the
tempo.
Chromatic PS
A two-voice pitch shifter that changes the pitch in semitone steps.
Parameter
Value
Explanation
PITCH1, PITCH2
-24–12 (semi)
Adjusts the amount that PITCH1 or PITCH2 is pitch-shifted.
BALANCE
100-0–0-100 (%)
Adjusts the volume balance between dry (the original sound) and effect sound.
PAN1, PAN2
L50–R50
Sets the panning of PITCH1 or PITCH2.
Hyper-Reso
This is a resonator effect that is adjusted to make creating melodies and bass lines easier.