Roland SP-404MK2 - Pad Set

Appendix
110
Parameter
Value
Explanation
The inputted MIDI signals are also transmitted to the internal sound module at that time.
GAIN
Parameter
Value
Explanation
Attenuator
OFF, ON
When this is ON, the gain of the audio input from the LINE IN jacks is lowered.
Turn the Attenuator on when the LINE IN input seems to be distorting.
Noise Gate
Reduces the noise floor in the signal input from the LINE IN and INPUT jacks.
OFF
The noise gate is not used.
-9dB, -12dB, -18dB
Reduces the noise floor at the specified level.
-Inf
Reduces the noise floor to the bare minimum.
LINE OUT
0, +6, +12 (dB)
Sets the gain of the audio output from the LINE OUT jacks.
PHONES OUT
-18, -12, -6, 0, +6, +12 (dB)
Sets the gain of the audio output from the PHONES OUT jacks.
USB OUT
-24, -12, 0 (dB)
Sets the gain of the audio output from the USB port.
VERSION
Displays the version of this unit.
PAD SET
TRIGGER
Parameter
Value
Explanation
Curve
Type
Sets how the volume changes according to how hard you strike a pad.
Lin
This is the standard setting. This produces the most natural balance between playing dynamics and
volume change.
Exp
Compared to “Lin”, playing strongly produces a greater change in volume.
Log
Compared to “Lin”, playing softly produces a greater change in volume.
Fix
Sets the volume at a fixed level of 127.
Threshold
1–
100
This sets the minimum sensitivity of the pads, at which the trigger signal is received only when a pad
is struck with at least a certain amount of force (velocity). This can be used to prevent a pad from
sounding due to vibrations from other pads.
Gain
0–
100
The sensitivity is adjusted with the curve as-is. The larger the value, the greater the sensitivity is when
playing the pads.
Trig Span
1–10
Adjusts the sensitivity of the pads to repeated strikes. With lower values, the pads detect repeated
strikes within a shorter time interval. Set this value higher if you don’t want the pad to accidentally
detect repeated strikes.
LED