Roland SP-404MK2 - Cassette Sim; Lo-Fi; Reverb; Chorus

Appendix
119
Parameter
Value
Explanation
FREQUENCY
0–100
Sets the frequency characteristics of the playback system.
NOISE
0–100
Adjusts the volume of the noise.
WOW FLUT
0–100
Sets the inconsistencies (wow/flutter) heard when the analog record “rotates”.
Cassette Sim
This effect simulates the sound of a cassette tape playing.
Parameter
Value
Explanation
TONE
0–100
Sets the tone.
HISS
0–100
Adjusts the volume of the noise.
AGE
0–60 (years)
Sets how many years the cassette tape has deteriorated.
DRIVE
0–100
Adjusts the amount of distortion.
WOW FLUT
0–100
Sets the inconsistencies (wow/flutter) heard when the cassette tape plays back.
CATCH
0–100
Sets how much the cassette tape has stretched out.
Lo-fi
Degrades the tonal character.
Parameter
Value
Explanation
PRE FILT
1–6
Sets the type of pre-filter (the filter that the sound passes
through before effects are applied).
LOFI TYPE
1–9
Larger settings cause more tonal degradation.
TONE
-100–100
Sets the tone. Larger settings emphasize the high-frequency
range. Smaller settings emphasize the low-frequency range.
CUTOFF
200, 250, 315, 400, 500, 630, 800, 1000, 1250,
1600, 2000, 2500, 3150, 4000, 5000, 6300,
8000 (Hz)
Sets the frequency range in which the post-filter (the filter
that the sound passes through after effects are applied)
works.
BALANCE
100-0–0-100
Adjusts the volume balance between dry (the original sound)
and effect sound.
LEVEL
0–100
Adjusts the volume of the effect sound.
This effect may output a very loud sound, depending on how the parameters are set. Use caution not to raise the values too
much.
Reverb
Adds reverberation to the sound.
Parameter
Value
Explanation
TYPE
AMBI, ROOM, HALL1, HALL2
Sets the type of reverb.
TIME
0–100
Sets the reverb time.
LEVEL
0–100
Adjusts the volume of the effect sound.
LOW CUT
FLAT, 20–800 (Hz)
Sets the frequency range at which the effect sound is attenuated.
HIGH CUT
630–12500, FLAT (Hz)
PRE DELAY
0–100 (ms)
Sets the time before the effect sound is output.
Chorus
Adds spaciousness and richness to the sound.
Parameter
Value
Explanation
DEPTH
0–100
Sets the depth of the effect sound.
RATE
0.33–2.30 (sec)
Sets the cycle (period) of the effect sound.
BALANCE
100-0–0-100 (%)
Adjusts the volume balance between dry (the original sound) and effect sound.
EQ LOW
-15–15 (dB)
Adjusts the amount of boost/cut of the low-frequency range.
EQ HIGH
-15–15 (dB)
Adjusts the amount of boost/cut of the high-frequency range.
LEVEL
0–100
Adjusts the volume of the effect sound.