Roland SP-404MK2 - Efx Set

Appendix
111
Parameter
Value
Explanation
LED
Brightness
1–10
Sets the brightness of the indicators on the buttons and pads. This sets the brightness when the
buttons or pads are highlighted.
LED Glow
1–10
Sets the brightness of the indicators on the buttons and pads. This sets the brightness when the
buttons or pads are not highlighted.
Pad LED
Mode
This selects the color of the pad illumination.
BUS
The pads light up in the color set in “BUS COLOR”.
In this mode, the pad colors change according to the bus through which the sample audio is sent.
PAD
The pads light up in the color set in “PAD COLOR”.
BUS COLOR
Parameter
Value
Explanation
BUS1 Color
BUS2 Color
DRY Color
Default, 1–127,
White
Changes the pad color for each bus through which sample audio is sent.
This can be set for BUS 1, BUS 2 and DRY respectively.
This is enabled when Pad LED Mode is “BUS”.
● Hold down the [SHIFT] button and turn the [VALUE] knob to change the value in
steps of 10.
PAD COLOR
Parameter
Value
Explanation
PAD-1–PAD-
16
Default, 1–127,
White
Specifies the colors of individual pads.
This is enabled when Pad LED Mode is “PAD”, and when a sample is either playing back
or stopped while in sample mode.
EFX SET
FAVORITE
Parameter
Value
Explanation
Routing
TYPE A, TYPE B
Selects the routing (connection) of the bus to which effects are assigned.
“Configuring the Effect Routing(P.93)”
FAVORITE
1–16
Selects the combination of effects assigned to BUS 3 and BUS 4.
“Changing the Effects Assigned to BUS 3 and BUS 4(P.94)”