Roland SP-404MK2 - Sbf; Stopper; Tape Echo; Timectrldly

Appendix
117
SBF
A sideband filter that lets specific frequency components pass through.
Parameter
Value
Explanation
INTERVAL
0–100
Sets the band interval. Larger values produce wider band intervals, and the frequency
of each band increases.
WIDTH
0–100
Sets the bandwidth. Larger values produce a narrower bandwidth, which further
isolates the specific frequency components that pass through the filter.
BALANCE
100-0–0-100 (%)
Adjusts the volume balance between dry (the original sound) and effect sound.
TYPE
SBF1, SBF2, SBF3,
SBF4, SBF5, SBF6
Sets the range in which the filter works.
GAIN
-INF, -52.3–+10.0
(dB)
Adjusts the volume of the effect sound.
Stopper
This effect lowers the sample playback speed, reproducing the sound of a turntable stopping.
Parameter
Value
Explanation
DEPTH
0–100
Adjusts how much the playback speed should be slowed down.
RATE
1/128, 1/64, 1/32, 1/16, 1/8, 1/4, 1/2,
1, 2
Sets the period at which the playback speed is changed.
RESONANCE
0–100
Adjusts the filter’s resonance level.
Increasing the value further emphasizes the effect, for a more
unusual sound.
FLT MOD
0–100
Attenuates the high-frequency range according to the playback
speed.
AMP MOD
0–100
Lowers the volume according to the playback speed.
Tape Echo
This is a virtual tape echo effect that gives a realistic tape delay sound.
The effect simulates the tape echo section of a Roland RE-201 Space Echo.
Parameter
Value
Explanation
TIME
10–800 (ms)
Sets the tape speed.
Larger values make the tape speed slower, which creates a longer interval between
delay sounds.
FEEDBACK
0–99
Adjusts the volume of the delay repeat sound.
LEVEL
0–100
Adjusts the volume of the effect sound.
MODE
S, M, L, S+M, S+L, M+L,
S+M+L
Selects the combination of playback heads to use.
W/F RATE
0–100
Sets the speed of wow/flutter (the complex variation in pitch caused by tape wear
and rotational irregularity).
W/F
DEPTH
0–100
Sets the depth of wow/flutter.
TimeCtrlDly
This is a delay in which the delay time can be varied smoothly.
Parameter
Value
Explanation
TIME
0–100
Sets the sound delay time.
FEEDBACK
0–99
Adjusts the amount of feedback for the effect.
LEVEL
0–100
Sets the volume of the effect sound.
L DAMP F
FLAT, 80, 100, 125, 160, 200, 250, 315, 400, 500, 630, 800
(Hz)
Sets the frequency range that is attenuated each
time the delay repeats.