Combining Samples to Create a Pattern (PATTERN SEQUENCER)
60
Creating a New Pattern (TR-REC)
Here’s how to create a pattern by setting the sample playback timing at the position you like on the steps.
This method of recording is suitable for creating drum patterns.
1.
Press the [PATTERN SELECT] button.
2.
Press the [REC] button.
Empty pads in which no patterns have been recorded blink red.
The metronome sounds when the “Metronome:PTN” parameter is “ON”, which is the SYSTEM parameter “CLICK(P.109)”.
Press pad [9] while holding down the [SHIFT] button to turn the metronome sound on/off.
3.
Press pads [1]–[16] that are blinking red to select the record destination pattern.
The unit enters pattern record standby mode, and the RECORD SETTING screen appears.
4.
Press the [REMAIN] button.
The pattern recording method switches to “TR-REC”.
5.
Set the parameters for the pattern.
Sets the pattern’s tempo.
[CTRL 2] knob
Sets the length of the pattern.
[CTRL 3] knob
You can set how much to slide the timing of the upbeats (the
strength of the shuffle feel). A setting of “0” results in no shuffle.
Settings in the range of +10–16 generally give a pleasant shuffle
[SHIFT] button +
[CTRL 2] knob
Specifies the time signature.
[SHIFT] button +
[CTRL 3] knob
Sets the volume of the metronome.
[REMAIN] button
Selects how the pattern sequencer records.
Real-Time
Records in real time.
The [REMAIN] button lights up at this time.
TR-REC
Records using TR-REC.
The [REMAIN] button blinks at this time.
6.
Press the [REC] button.
TR-REC pattern recording begins.
7.
Press pads [1]–[16] while holding down the [SUB PAD] button to select a sample.
8.
Set the parameters for the sample to input.
[CTRL 1] knob
You can split up the steps into multiple and separate units (sub steps).
You can also configure how the split sub steps are played.
* This is enabled when MODE is “TRIG”.
To Next Page
Loading...
